P0448 Evaporative Emission Control System Vent Valve/Solenoid Circuit Shorted
OBD-II Trouble Code Technical Description
Evaporative Emission Control System Vent Valve/Solenoid Circuit Shorted
What does that mean?
This code is a generic powertrain code. It is considered generic because it applies to all makes and models of vehicles (1996-newer), although specific repair steps may vary depending on the model.
The Powertrain Control Module (PCM) has detected that the circuit is shorted together that controls the vent valve or solenoid for evaporative emission systems vapor. In this case the code will also be thrown when the valve is stuck closed.
As fuel sits in the tank it lets out fuel vapor, while driving this vent opens and allows the vapors to be circulated into the engine intake manifold, a charcoal canister or into the atmosphere, depending on the vehicle. This vent valve is apart of the simple, yet complicated evaporative emissions system.
Symptoms of a P0448 DTC will include Malfunction Indicator Lamp (MIL) illumination, you will likely not notice any other symptoms.
Potential causes may include:
- Faulty vent valve
- Wire/circuit issue
- PCM fault
Some steps to take to diagnose and repair this trouble code include the following:
Check your fuses, there may be a fuse that powers the vent solenoid.
Check for a rubbed-through or chafed wiring harness. Check both wires to see if they are shorted to each other, to ground or power.
Visually inspect the vent valve for cracks or damage.
Trace the wires to and from the PCM and check for continuity continuity using a digital volt ohm meter (DVOM).
If you have access to an advanced level scan tool, actuate the valve while reading power and ground at the connector or by simply using a bulb wired to both terminals, it will light up if power and ground are OK.
Using a DVOM, check the resistance of the vent, in most cases the resistance reading should be low, refer to the manufacturer’s specification or compare it to a new one. Too high or low a value indicates a faulty coil inside the valve, thusly meaning replacement is necessary. This code seems to be prevalent on Dodge, Chrsyler, and Jeep products. In those cases the vent valve was bad. With GM products (specifically pickups), GM has released a new updated valve assembly.
Finally, remove the valve, you may be able to access the pintle inside and it simply could just be sticking from fuel residue. Clean it and retest.
Related P0448 DTC Discussions
- code p0448 on 2011 nissan frontier
Measured the voltage going to the vent control vent valve and only has 10.85 volts. Is that enough to operate the vent valve properly?...
- 2004 dodge ram 1500 p0448
Only idles for few minutes in cold weather before engine stalls starts right back but does same thing wont idle on own till engine warms up...
Need more help with a p0448 code?
If you still need help regarding the P0448 trouble code, please post your question in our FREE car repair forums.
NOTE: This information is presented for information purposes only. It is not intended as repair advice and we are not responsible for any actions you take on any vehicle. All information on this site is copyright protected.