P0102 OBD-II Trouble Code

Technical Description

Mass Air Flow (MAF) Circuit Low Input

What does that mean?

Basically this means that there is a problem with the Mass Air Flow (MAF) sensor or circuit. A more technical description would be that the MAF circuit had lower than expected voltage (air flow).

Symptoms

You will likely not notice any serious drivability problems, although there may be symptoms such as a general decrease in power or sluggishness.

Causes

A code P0102 may mean that one or more of the following has happened:

• The MAF may be disconnected, or a wiring connection may be bad
• The MAF may be dirty or otherwise contaminated (Note: if you use a reusable oiled air filter, be careful not to apply too much oil or that can contaminate the MAF).
• The MAF sensor may be faulty
• The vehicle computer may be faulty (very rare)

Possible Solutions

The simplest thing to do is to reset the code and see if it comes back. Then start with the cheapest, easiest repair procedures:

• Verify that the Mass Air Flow Sensor wiring is connected properly and that there are no broken / frayed wires.
• Inspect for any air leaks near the MAF sensor.
• Take the MAF out and clean it using a spray cleaner such as brake cleaner or electrical contact cleaner. Be gentle with the sensor.
• Check the voltage of the MAF sensor (refer to a repair manual for vehicle specific information)
• Replace the MAF sensor.

Need more help?

If you still need help regarding the P0102 trouble code, please post your concern in the forums.

NOTE: This information is presented for information purposes only. It is not intended as repair advice and we are not responsible for any actions you take on any vehicle. All information on this site is copyright protected. If you want to share this article or information with others, please link to this page, don't copy and paste it elsewhere.